Six front panel gain pots, signal presence and clip indicators make setup a snap! A convenient Bus Mode switch allows one stereo input to be routed to all three pairs of amplified outputs without the need for additional patch cables. Independent Bridge Mode buttons allow mixing of bridged and un-bridged channels. Buffered line level outputs can be Y-corded for mono signal applications. The built-in IR connecting block can power up to four IR receivers and emitters great for standalone IR control applications!

Author:Dagami Faugis
Language:English (Spanish)
Published (Last):4 March 2010
PDF File Size:20.98 Mb
ePub File Size:7.96 Mb
Price:Free* [*Free Regsitration Required]

Impedance Match adjust- ments allow multiple pairs of speakers to be connected to the same amplifi- er channels without damaging the amplifier. Impedance Matching: Allows multiple speaker pairs to be connected to a single pair of amplifier channels. IR can be sent from the IR output to source equipment, IR distribution networks or whole-house controllers.

When voltage is absent, the VSE goes into Mute. A physical button press is required to un-Mute this device. This allows the system or zone to be turned on without all of the VSEs in the system playing audio. The VSE fits into most 18 cu. P-rings allow the best access and depth and should be used where local building codes allow.

Close proximity to high-voltage devices can also cause undesired IR operation. Please do not mount the unit in locations susceptible to these conditions. The speaker terminals on this unit will accommodate 14 to 24 AWG stranded copper speaker wire. Runs that exceed feet should use heavier gauge wire, but 16 or 18 AWG is usually sufficient.

Check local building codes for specific guidelines regarding in-wall wire runs. This unit must be connected to power in order to function. Once proper connections are made at the head-end, plug the RJ45 connector into the jack on the rear of the VSE Install the unit in the wall using the provided screws.

Be careful not to place tension on the CAT5 cable. Test and adjust. Verify that the amplifier is powered down. Twist and verifythat there are no frayed ends.


Elan Z Series Z630/631 Pre-Amp Controller

Moogugor For additional information, see the Global Shipping Program terms and conditions — opens in a new window or tab This amount includes applicable customs duties, taxes, brokerage and other fees. This item will be shipped through the Global Shipping Program and includes international tracking. Learn More — opens in a new window or tab International shipping and import charges paid to Pitney Bowes Inc. Enter text from picture: Page 10 Bass and Treble. Interest will be charged to your account from the purchase date if the balance is not paid in full within 6 months.


This website appears to be a copy of the original and may not be safe to view.

To print the manual completely, please, download it. Similar sponsored items Feedback on our suggestions — Similar sponsored items. Sell one like this. Image not available Elaan not available for this variation. Control up to three zones via remotes or keypads. Once the programming is done it is downloaded to each keypad and touchpanel using the learner which connects to the serial port on your laptop and plugs into the keypad. We know these products inside and out, and are happy elann give you some obligation free advice in store, via email, or over the phone to ensure that this is the solution for you.


Elan Z-630 Series II Manuals


Related Articles